[hpsdr] Project proposal - Hermes
Lyle Johnson
kk7p at wavecable.com
Sat May 23 08:18:02 PDT 2009
Hello Kevin!
Looking over the information for Hermes in the wiki, a few thoughts.
1) Delete the LTC6400-20 preamp. We can get differential drive to the
ADC using a transformer. The 6400 reduces the dynamic range of the
system somewhat and complicates the design as well as raising the cost.
2) Since off-board receive input filters are going to be needed anyway,
a suitable preamp and attenuator can be incorporated on that board. If
Alexaires is the intended filter, perhaps it can be modified to include
a suitable preamp for the upper HF range. Or use of the RX1 in/out
jacks on Alexaires can accommodate such a preamp.
3) The National LM4950TS makes a reasonable speaker amplifier. It is a
linear device, so no switching noise. The TPA2017 is interesting, but
I'd be a little concerned about noise, including serious power supply
decoupling since it shares the same analog domain as the LTC2208.
---
This looks to be an exciting project!
73,
Lyle KK7P
More information about the Hpsdr
mailing list