[hpsdr] LPU Assembly

[Scott Cowling]

Hi Gordon,

For my test build I used a pair of needle nose pliers, carefully 
crimped the sockets and then soldered them. Use the solder sparingly 
to avoid flowing in into the socket itself.

A somewhat tedious process, but it actually works better than the crimper.

73,
Scotty WA2DFI

At 16:53 2009-05-07 -0400, you wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>
>I just came to the computer to ask about the heat sink/regulator 
>issue and found the problem solved.  I then went on to the next 
>step, which calls for a Molex crimper.  I then went to Allied's web 
>site and found it cost $252.07.  So, my next question is, what 
>advice is there on how to proceed without the crimper?
>
>Gordon, KA2NLM
>
>_______________________________________________
>HPSDR Discussion List
>To post msg: hpsdr at openhpsdr.org
>Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>HPSDR web page: http://openhpsdr.org
>Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/



 1241734828.0