[hpsdr] Spectrum Analyzer Software Feature for Mercury

[Tom Cathey]

Hi Joe,

Thanks for the reply.

No, unfortunately, that would not do it.  The cursor reads the static position of where it is on the screen.  

I would like the reading to be dynamic and change with the two signal levels so that the side crud, 3khz away from the main signal, would be shown in  –db.     

I suppose a second receiver could do this, though we would have to mentally subtract the two levels to get an IMD figure.
Some of the high end commercial spec analyzers will let us put a bug on the screen and it will calculate these difference levels. 


Hmmm... maybe one Merc receiver cannot monitor a second frequency – is this the limitation?

Tom




From: Joe Martin K5SO 
Sent: Sunday, December 09, 2012 4:53 PM
To: Tom Cathey 
Cc: hpsdr at openhpsdr.org 
Subject: Re: [hpsdr] Spectrum Analyzer Software Feature for Mercury

Tom,  

In PowerSDR, when the cursor is in the panadaptor window the position of the cursor is shown (in dBm) just below the panadaptor display on the left side.  Won't that do what you require?  

Just put the cursor on the point you want measured.  Yes?

73, Joe K5SO

On Dec 9, 2012, at 2:46 PM, Tom Cathey wrote:


  ***** High Performance Software Defined Radio Discussion List *****


  Hi All,

  This may have been covered before, but here’s my idea for a software addition...

  I use my Mercury receiver often as a spectrum analyzer to measure my final linear’s IMD.  (3-1000z, 8877, etc)  I sometimes like to compare one amplifier against the other to see the effects on drive, loading and other parameters. After some testing, we can usually find the sweet spot and then know where to run the amplifier for cleanest operation.

  With the present PwrSDR software, it is difficult and time consuming on the fly to interpret the IMD without counting grid lines, etc.  A nice feature to have would be to be able to set a distance from the main signal and see an ongoing numerical reading of how far down in db this level is.  For example, if your transmit signal is on  3700 using a two tone – and we punch in 3703 as the test point, a readout might show the side trash signal 3khz away is –35db.   By changing various amplifier parameters, we could see the best settings as this number changed.  Moving out farther, like 5kc, etc could start to show the rough 5th, 7th order, etc IMD numbers.

  I understand that a Cyclops spec analyzer is coming out, but could this feature be considered for the PWRSDR software so that the Mercury could use it too?

  Or is there a way to do this now that I am missing?   What do you think?

  Thanks.

  Tom, K1JJ

  _______________________________________________
  HPSDR Discussion List
  To post msg: hpsdr at openhpsdr.org
  Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
  HPSDR web page: http://openhpsdr.org
  Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20121209/a8b0e136/attachment-0003.htm>