[hpsdr] picoPSU Noise Test

[Christopher T. Day]

Achim,

Let's be careful not to get the cart confused with the horse. The
numbers quoted below are the specs for the picoPSU-60-WI, NOT for HPSDR.
I doubt that the latter can be specified at this point or even if they
should be. The only spec is that the ATX required voltages _will_ be
present. Since this is an open project, people are expected to
experiment, try different combinations of boards, etc. What is needed as
a PSU is allowed to vary from implementation to implementation. The
picoPSU's should only be considered as examples of what should be enough
- maybe - for a simple configuration of some of the cards in play. Your
mileage and horsepower may vary.


	Chris - AE6VK


-----Original Message-----
From: Achim Vollhardt [mailto:avollhar at physik.unizh.ch] 
Sent: Friday, June 09, 2006 6:18 AM
To: hpsdr at hpsdr.org
Subject: Re: [hpsdr] picoPSU Noise Test

***** High Performance Software Defined Radio Discussion List *****

...

Is the following the specs for the HPSDR?

5V 6A 10A 1.5%
5VStand By 1.5A 2A 1.5%
3.3V 6A 8A 1.5%
-12V 50mA 50mA 5%
12V 400mA 450mA 3%

(took it from a picoPSU post earlier)

...


 1149878799.0