[hpsdr] Mechanical considerations for ATLAS cards

[Alex]

Ok, I'll draw it up an post a link later today.

----- Original Message ----
From: Philip Covington <p.covington at gmail.com>
To: Alex <harvilchuck at yahoo.com>
Cc: hpsdr at hpsdr.org
Sent: Friday, May 19, 2006 12:28:53 PM
Subject: Re: [hpsdr] Mechanical considerations for ATLAS cards

Hi Alex,

A picture is worth a thousand words... can you draw something up so we
can see exactly what you are proposing?

73 de Phil N8VB


On 5/19/06, Alex <harvilchuck at yahoo.com> wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
> I've got a few points to lobby the group on mechanical factors of cards on the ATLAS bus:
>
> (a) Can we modify the 100mm high by 100mm wide form factor to be 100mm high by  200mm wide?
> (b) Can we state that the card orientation method is component side AWAY from the ATX power connector
> (c) Can we modify any external connectors to be, looking at the card from the component side, on the left perpendicular side
> (d) Any intra-chassis connections/headers (JTAG, etc.) would be located on the side parallel (top side of card) to the ATLAS connector.
>
> If we did this we would have a little more area for circutry AND for us folks who want to rackmount by using off-the-shelf ATX computer cases (good 4U units are less that $120 in single quantities). Then we don't need to build a mount for the power supply, don't need to build a mount for the external connectors (just have a mounting bracket fabricated), and you can mount a LCD display in the open front drive bays.
>
> Alex, N3NP
>
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
>




 1148056266.0