[hpsdr] Some thoughts on plug-in board layout

[Alex]

Plus we need to agree where the DIN connector is located on the "bottom" of the card. 
How far is it from the "rear" or "left" edge.
 
Alex, N3NP

----- Original Message ----
From: Lyle Johnson <kk7p at wavecable.com>
To: Philip Covington <p.covington at gmail.com>
Cc: Open High Performance SDR Project <hpsdr at hpsdr.org>
Sent: Thursday, May 25, 2006 4:48:06 PM
Subject: Re: [hpsdr] Some thoughts on plug-in board layout


***** High Performance Software Defined Radio Discussion List *****

Phil,

>> I see pluses and minuses to each form factor.  I don't have any
>> problem changing it or redoing the OZY layout (since it isn't too far
>> along).  Lyle is further along on JANUS and he makes some good points
>> about signal flow in a previous post.  It matters less with the OZY
>> board since it is pretty much all digital signals (other than the USB)
>> and there are not the concerns of separating the analog and digital
>> sections like there is in the JANUS.
>>
>> Take a look at the drawing about and please comment.  We need to get
>> this resolved soon so we proceed with the JANUS and OZY.

This makes the smallest card 100mm high and 120mm wide if I understand 
the drawing correctly.

I'll see if I can fit Janus into this footprint.

73,

Lyle KK7P

_______________________________________________
HPSDR Discussion List
To post msg: hpsdr at hpsdr.org
Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
HPSDR web page: http://hpsdr.org
Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/

 1148596806.0