[hpsdr] [QRP-L] PCB Prototype house

[Darrell Harmon]

Lyle Johnson wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
>   
>> I'm needing to make several 4 layer Eurocard (160mm x 100mm) size PCB's
>> and I'm looking for recommendations on an outfit that will do it for a
>> reasonable price. The quantities will be small 1 or two boards
>>     
>
> I always use < URL:http://www.protoexpress.com > for multilayer 
> prototypes that meet their "no touch" limitations.  13+ years and no 
> problems.
>
> 73,
>
> Lyle KK7P
>   
I also use the protoexpress no touch service and get good results. The 
soldermask has gotten a bit thin lately, but no issues with the copper. 
I have done very dense boards with them and had no problems. They will 
not talk to you on the phone about no touch orders, and there is no 
checking of the gerbers. They will run whatever you send even if pads 
are masked over or other mistakes exist. The current price for 4 layer 
up to 60 square inches is $51 per board with a minimum of 3 boards. 
Also, I believe Advanced circuits has a 3 boards for $200 special now ( 
http://www.66each.com and http://www.4pcb.com ). They do a decent design 
check and email a report.

Darrell Harmon

 1168471777.0