[hpsdr] Penelope PTT

[Gerd Loch]

Hi Phil,

I have changed the priority of PowerSDR to Realtime in the task manager but
the behaviour is the same.
If you use slow relais you will probably not notice the short interrupts.

Next I will check which software rev. is in the flash.

73, Gerd
DJ8AY



-----Ursprüngliche Nachricht-----
Von: Phil Harman [mailto:phil at pharman.org] 
Gesendet: Sonntag, 17. August 2008 07:03
An: g.loch at nt-electronics.de; hpsdr at hpsdr.org
Betreff: Re: [hpsdr] Penelope PTT


Hi Gerd,

I also use this output to control my antenna relays but do not have a 
problem.  Try setting the priority of PowerSDR to Real-time and see if that 
helps since it sounds like you may be dropping packets over the USB.

73's Phil...VK6APH


----- Original Message ----- 
From: "Gerd Loch" <g.loch at nt-electronics.de>
To: <hpsdr at hpsdr.org>
Sent: Saturday, August 16, 2008 9:27 PM
Subject: [hpsdr] Penelope PTT


> ***** High Performance Software Defined Radio Discussion List *****
>
> I am using pin 13 on the 25 pole connector on Peneople to switch my
> antenna
> relais. I have short interrupts on this line because I hear the relais
> clicking every few seconds. Is this an issue with software or what else
> could be the reason?
>
>
> Gerd, DJ8AY
>
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.138 / Virus Database: 270.6.3/1614 - Release Date: 
> 8/15/2008
> 5:29 PM
>
> 



 1218979617.0