[hpsdr] OZY FPGA Configuration

[Gerd Loch]

On Ozy the Cyclone II FPGA is being configured by the FX2 chip (Pins 72-77).

The signals are:

FPGA_DATA0          FX2 Pin72
FPGA_NCONFIG        FX2 Pin73
FPGA_DCLK           FX2 Pin74
FPGA_CONFIG_DONE    FX2 Pin75
FPGA_NSTATUS        FX2 Pin76
FPGA_NCE            FX2 Pin77

There is also a different way to configure the FPGA, the active serial mode.
For this mode the Flash U1 must be programmed by an external programmer
(Byteblaster II) which can be connected through HDR1.

This progammer uses partly the same signals described above.
    
For example the signal FPGA_DCLK is an output on FX2, but it is also an
output on the Bytblaster II 
(Pin 1 HDR1) which results in output against output.

Would it be a risk to connect the Byteblaster II or am I missing something?

Gerd, DJ8AY