[hpsdr] SDR-1000/Janus/Ozy TX locked on

[Bill Tracey]

What  version of PowerSDR are you using? Specifically  I'm interested 
in the date in the titlebar of PowerSDR.

What is the FX2 and Ozy levels shown in the setup->general->HPSDR 
page?  Do you have Janus/Ozy Control selected on General->Hardware 
Config?  Also, do you have the DB 25 on Ozy connected to the DB25 on 
the SDR 1000?

You can also try starting PowerSDR with the --ignore-pp-ptt argument 
- this will explicitly force the code to ignore the PC"s parallel 
port as a PTT source.

Regards,

Bill  (kd5tfd)


At 09:34 PM 8/5/2009, lstoskopf at cox.net wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>I feel like I'm dropping back to the dark ages. Pulled the SDR-1000 
>off the shelf, pulled Penny and Mercury out of Atlas, installed 
>Janus and hooked up everything as per Janus and Ozy, Operation with 
>PowerSDR v. 2.0.  Goal is to get back to using as driver for a 
>handful of somewhat neglected UHF transverters.
>
>Everything loads well.  I've got a whole string of leds lighting up 
>on Ozy where v. 2.0 indicates only one.  All of the controls work 
>well.  But when I hit Start with CW enabled I get MOX on and iambic 
>CW.  No way to get to RX.  In AM mode can set drive to Max and get 
>.16  watt on the meter.  Again, no way to get to RX.
>
>I have two OZY cards, one with latest firmware and the other 
>not.  One awaiting dedicated use with Janus for a digital 
>upconverter.  No difference between the two.
>
>Anyone know if I did some typical mistake in setup.  Have checked 
>and re-checked jumpers, etc.
>
>Thanks,  N0UU



 1249536088.0