[hpsdr] First run

[Henry Vredegoor]

Hi Alberto,

The only way you can route the audio to your PC audio output (soundcard is
trough "VAC" - Virtual Audio Cable.
It comes at a cost of extra delay though, on my machine.

Better to use the lower 3,5 mm jack on Mercury itself.

Henry.

> -----Original Message-----
> From: hpsdr-bounces at lists.hpsdr.org 
> [mailto:hpsdr-bounces at lists.hpsdr.org] On Behalf Of Graham / KE9H
> Sent: donderdag 12 februari 2009 0:52
> To: Alberto I2PHD
> Cc: HPSDR List
> Subject: Re: [hpsdr] First run
> 
> 
> ***** High Performance Software Defined Radio Discussion List *****
> 
> Alberto I2PHD wrote:
> >
> >
> > a) Is this display of the firmware level correct ? 
> Shouldn't Mercury 
> > show 26 (or 2.6) ?
> Mercury should show 26 if you have loaded it into the card properly.
> 
> Did you follow the ReadMe instructions at
> svn://206.216.146.154/svn/repos_sdr_hpsdr/trunk/USBBlaster-Binaries
> and get a positive result?
> 
> What version of PowerSDR are you running?  11February is the latest.
> 
> >
> > b) I don't hear any audio, but I haven't connected anything to the 
> > audio output jack of Mercury.
> >   Is there any way to have the audio output routed to the PC sound 
> > card ? On the Setup | Audio | Primary
> >   panel everything is grayed except the Buffer SIze and Sample Rate
> Correct.
> The only audio output port is the two audio connectors on the back of 
> the Mercury card.
> It can not be sent directly to your computer audio system.
> 
> --- Graham / KE9H
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
> 


 1234398269.0