[hpsdr] First run

[Graham / KE9H]

Alberto:
Yes, you need to download the Quartus programmer and
use it in conjunction with Ozy to simulate a Byte-Blaster
to put the code load into Ozy.  If you own a Byte-Blaster,
you can put it in directly.
--- Graham



Alberto I2PHD wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
>   
>
> ------------------------------------------------------------------------
>
> Graham / KE9H wrote:
>> Alberto I2PHD wrote:
>>   
>>> a) Is this display of the firmware level correct ? Shouldn't Mercury 
>>> show 26 (or 2.6) ?
>>>     
>> Mercury should show 26 if you have loaded it into the card properly.
>>
>> Did you follow the ReadMe instructions at
>> svn://206.216.146.154/svn/repos_sdr_hpsdr/trunk/USBBlaster-Binaries
>> and get a positive result?
>>
>> What version of PowerSDR are you running?  11February is the latest.
>>   
> Well, PowerSDR works, and now that I have enabled VAC I can hear audio 
> correctly. I have done the calibration setup
> and the levels now agree with those of Perseus. That notwithstanding, 
> I still  have that indication, as reported in my
> previous message, for the level of the Mercury firmware.
>
> PowerSDR has been downloaded a couple of hours ago from the PennyMerge 
> branch, SVN revision 2675,
> dated Feb. 11.
> The audio now is routed through VAC to the PC sound card, no problems 
> here.
>
> But probably I had erroneously thought that PowerSDR did load itself 
> the V2.6 into the FPGA...
> Do you confirm that I have to go through the Altera Quartus II 
> Programmer application route to update that firmware level ?
>
> 73  Alberto  I2PHD
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/



 1234400236.0