[hpsdr] Updated Firmware Software.

[Jeff Cook]

I'm having very similar problems to Keith's.  Installing updated 
firmware/software went without a hitch but the results were unusable 
with my boards in their usual positions in Atlas.  Not possible to do 
the calibration routine due to severely distorted audio.  However if I 
put Mercury, Penelope and Ozy in consecutive slots in that order 
starting with Mercury next to the power socket it works, even with the 
sample rate set at 192000, which I've not been able to use before.

Will do some more testing and if anything significant shows up I will 
report back.

PS.   In case it's of any significance I should tell you that I'm using 
v8 of Quartus.  The link in Phil's README.text leads to a page 
unavailable notice. Starting at the homepage I could not find the 
Quartus II Programmer Application (80 MB), I could only find two 
freeware applications, one at 1 GB and the other at 800 MB.  This may 
well be down to stupidity on my part I'm about as bright as a Toc H lamp.