[hpsdr] Penelope T2 Wire Configuration
Bruce Beford
bruce.beford at myfairpoint.net
Fri Nov 13 03:37:32 PST 2009
All the HPSDR board docs are available on the HPSDR webpage, by using the
Support link on the left side of the home page. The Penelope schematic is
here:
http://openhpsdr.org/support/Penelope/Penelope_schematic_A1.pdf
I would look carefully at the other two pads on the center tapped side. The
center pin should have 2 wires, the outer pins should each have one wire
attached. Based on that, it should be pretty easy to decide where it goes.
Good luck,
Bruce N1RX
1258112252.0
More information about the Hpsdr
mailing list