[hpsdr] Stupid question re PowerSDR+Janus+SoftRock

[K1rqg at aol.com]

Murray
 
Have you tried selecting SETUP> HARDWARE CONFIG> SOFTROCK 40.
Then under SDR-1000 config, select Janus/Ozy Control. Center  frequency
select is displayed under SoftRock options.
 
73 de Joe
 
 
In a message dated 12/18/2010 9:15:38 A.M. Eastern Standard Time,  
murray.lang at westnet.com.au writes:

*****  High Performance Software Defined Radio Discussion List  *****

Unfortunately the W5WC version is the same - no obvious way to  set the 
centre frequency when HPSDR+Janus is the hardware selection.
Is  anyone out there using a SoftRock+Janus+PowerSDR setup?

73,
Murray  VK6HL

On 18/12/2010 9:27 PM, Murray Lang wrote:
> ***** High  Performance Software Defined Radio Discussion List *****
>
> Hi  Roland,
>
> I have the KD5TFD version (17 Dec 2010). This has no  centre frequency 
> setting when HPSDR and Janus are selected. I'll have  a look for a W5WC 
> version - thanks.
>
> Murray  VK6HL
>
> On 18/12/2010 8:39 PM, roland etienne wrote:
>>  Hi Murray,
>>
>> I suppose you are using W5WC version of  Power sdr, in wich case the 
>> center
>> frequency can be  set in the setup, General, Hardware config tab.
>>
>> And if  your Softrock RxTx is using a SI570, with this version of 
>>  PowerSDR
>> you can command the SI570 via Ozy, you just need to wire  the I2C 
>> correctly.
>>
>> Hope this  helps,
>>
>> 73, roland  F8CHK.
>>
>>
>>
>>> -----Message  d'origine-----
>>> De : hpsdr-bounces at lists.openhpsdr.org  [mailto:hpsdr-
>>> bounces at lists.openhpsdr.org] De la part de  Murray Lang
>>> Envoyé : samedi 18 décembre 2010  13:19
>>> À : hpsdr at lists.openhpsdr.org
>>> Objet :  [hpsdr] Stupid question re  PowerSDR+Janus+SoftRock
>>>
>>> ***** High Performance  Software Defined Radio Discussion List *****
>>>
>>>  Hi all,
>>>
>>> I've finally got around to trying to  set up Janus with my SoftRock TXRX
>>> but have been stumped by a  most basic and necessary requirement: How do
>>> I tell PowerSDR  the centre frequency of my SoftRock? The document 
>>>  "Janus
>>> and Ozy Operation with PowerSDR" mentions the SoftRock  but does not 
>>> even
>>> contain the word  "frequency". I can't find any reference on the web to
>>> this  problem so it's either bleeding obvious or nobody is using 
>>>  PowerSDR
>>> with Janus and a SoftRock (hard to  believe).
>>>
>>> At this stage I would be very  pleased to have my poor investigative
>>> skills laid bare in  return for an answer.
>>>
>>> 73,
>>>  Murray VK6HL
>>>
>>>  _______________________________________________
>>> HPSDR  Discussion List
>>> To post msg:  hpsdr at openhpsdr.org
>>> Subscription help:  http://lists.openhpsdr.org/listinfo.cgi/hpsdr-
>>>  openhpsdr.org
>>> HPSDR web page:  http://openhpsdr.org
>>> Archives:  http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>>
>>
>
>  _______________________________________________
> HPSDR Discussion  List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:  
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>  HPSDR web page: http://openhpsdr.org
> Archives:  http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>

_______________________________________________
HPSDR  Discussion List
To post msg: hpsdr at openhpsdr.org
Subscription help:  
http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
HPSDR web page:  http://openhpsdr.org
Archives:  http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20101218/957da5ab/attachment-0002.htm>