[hpsdr] Ozy Failure

[John Melton]

Hi Joe,

U14 is putting out 3.3v and also U10 is puuting out 1.2v so all the
voltages look to be OK.

-- John

On Fri, 2010-07-23 at 10:42 -0400, K1rqg at aol.com wrote:
> John
>  
> Check U-14 for proper operation.
>  
> 73 de Joe
> K1RQG
>  
> In a message dated 7/23/2010 10:32:22 A.M. Eastern Daylight Time,
> john.d.melton at googlemail.com writes:
>         ***** High Performance Software Defined Radio Discussion List
>         *****
>         
>         
>         My Ozy board seems to have failed.  I only have the D12 led on
>         and my
>         computer does not see the USB device any more.  It is  TAPR
>         built Rev B
>         board.
>         
>         I have checked voltages on my LPU and on the Atlas bus and
>         they all look
>         OK.  I have also tried plugging in an ATX power supply with
>         the same
>         results.
>         
>         Any ideas on where to start looking?
>         
>         Regards,
>         
>         John g0orx/n6lyt
>         
>         _______________________________________________
>         HPSDR Discussion List
>         To post msg: hpsdr at openhpsdr.org
>         Subscription help:
>         http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>         HPSDR web page: http://openhpsdr.org
>         Archives:
>         http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/



 1279896666.0