[hpsdr] Metis power requirements

[Phil Harman]

Please note that with Metis running at 1Gb/s the +5v supply current will
increase by approximately 0.75A.

For this reason (for folks that are using LPUs), and the fact that we
don't need 1Gig rates to the PC just yet, the initial release of Metis
code will run at 100Mb/s.

73 Phil...VK6APH




> ***** High Performance Software Defined Radio Discussion List *****
>
> With Penny, Mercury, Metis & Excalibur, I measure 1.73 amp on the +5v
> supply.
> (Metis ethernet running at 100Mb/s)
> (+12v supply not currently connected, but necessary for Penny's RF power
> amp.)
> 73,
> Dave
>
> Keith wrote:
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>>
>>
>> ------------------------------------------------------------------------
>>
>> Was wondering if anyone has measured the amount of dc current being
>> drawn by Metis in an HPSDR with Penny, Mercury, and Excalibur installed?
>>
>> Thanks
>>
>>
>>
>> Keith, N3ICK
>>
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> HPSDR Discussion List
>> To post msg: hpsdr at openhpsdr.org
>> Subscription help:
>> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>> HPSDR web page: http://openhpsdr.org
>> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>



 1294821969.0