[hpsdr] Alex Observation #2

[Graham / KE9H]

Hi Dan:

I'll look into this.

There is a one Amp, self resetting fuse, on the Mercury board, in
the power feed line to ALEX, so a short to ground on +12 Volts on
ALEX should not damage anything.

I'll check the connector numbering, and add a note in the Manual
if there is a problem.

--- Graham / KE9H

==

On 9/1/2011 10:41 AM, Dan Mitchell wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
> If you want to use the 4-pin connector at the rear of the Alex TX board to
> monitor FWD and REV power, be aware that, due to the way the connector is
> keyed, the wiring is REVERSED to that that appears at the 4-pin connector at
> the front of the Mercury board.
> 73,
> Dan, W0IQ
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>


 1314973124.0