[hpsdr] Alex coupler w/Hermes

[Joe Martin K5SO]

Hi John, 

When testing out your system I firmly believe that you should always use the latest software and firmware, then after ascertaining in that way that your hardware connections are correct and that your system is operating normally, you may test earlier versions of software or firmware as you desire to see if things still work for you.  If they don't, then you've answered your own question.  

The current version of RX2 PowerSDR is v2.2.6 dated 12 December 2012;  Hermes is v2.0.  

Using the current versions of PowerSDR and Hermes, FWD/REF power work fine with Alex here.  

73,  Joe K5SO

On Dec 21, 2012, at 7:42 AM, John wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> 
> Should I be able to measure FWD/RFL power using Hermes with Alex and PowerSDR (v. 2.2.3)?
> 
> With a straight key connected to Hermes I hear sidetone and relays clicks in Alex when the key is closed, but see no indication of FWD or RFL power on the PowerSDR presentation.    I have tried with Alex ANT 1 connected to my antenna and also to a 50 Ohm dummy load.  Hermes TXout (J3) is connected to Alex 'From TX'.
> 
> If I run the Wizzard, the Alex relays seem to click randomly in receive and I have to stop Hermes in PowerSDR to stop the clicking relays.
> 
> Hermes firmware was updated earlier this week.
> 
> John,  W0GN
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/


 1356105880.0