[hpsdr] [apache-labs] hermes resistor removal

[Ken N9VV]

Hi Mike,
Sorry, I have not built the kit. I wonder if persons on the OpenHPSDR 
group might have more experience and can help you with the details?

Have you tried over there?

BK de Ken N9VV

On 11/30/2012 10:45 AM, mstangelo at comcast.net wrote:
> Ken,
>
> Should we alos desolder R145 as well as R102 before we install SW1?
>
> Mike N2MS
>
> ----- Original Message -----
> From: Ken N9VV <n9vv at wowway.com>
> To: apache-labs at yahoogroups.com
> Cc: David <g4fre at g4fre.com>
> Sent: Fri, 30 Nov 2012 16:26:05 -0000 (UTC)
> Subject: Re: [apache-labs] hermes resistor removal
>
> Dave, if you go to the PA upgrade kit instructions manual, it shows
> removal of one resistor prior to installation of the power switch as
> step 1 of the instructions:
> "1. Desolder R102
>    2. Solder SW1 (supplied with the Kit), Chrome cap can be installed
> prior to soldering"
>
> The document is a pdf and is located in the FILES section of our Yahoo
> Group: "10W PA kit Instructions.pdf"
>
> <URL:
> http://f1.grp.yahoofs.com/v1/ANi4UNq7PUM0-6ofmOjxk5AQskTiBEYvdHuTm7Aculx6Iu3Ki0iBrMU3QAQx8txuy2LgvtGiOnnFc6oehgOLaA/10W%20PA%20kit%20Instructions.pdf
>   >
>
> GL de Ken N9VV
>
> On 11/30/2012 10:12 AM, David wrote:
>> on page 12 of "Hermes_User_Manual_V1.9.pdf" it says "If resistors R102
>> and R 145 are removed from the bottom (of hermes) the Apache Labs power
>> switch may be installed"
>>
>> yet in the document "10W PA kit Instructions.pdf" on the apache labs
>> site there is no mention of this alteration
>>
>> I assume these resistors have to be removed as currently my hermes board
>> takes no notice of the power switch?
>>
>> Dave
>>
>> ww2r
>

-- 
http://groups.yahoo.com/group/apache-labs/
http://www.n9vv.com/
[GMT-5]