[hpsdr] TAPR Hermes Arrived Today

[Dan Babcock]

Hi Larry,

There is no confusion over using the Hermes board as a receiver. :>)  Plug in an RJ45 connector from a Cat 5 cable that has the other end connected to a router on your LAN.  Hook up an antenna to the RX SMA connector.  Plug an 1/8 inch audio plug from a speaker into the appropriate connector on Hermes.  If you are super paranoid attach a dummy load or 50 Ohm termination to the TX SMA connector.  Apply power to the board.  Start up a correctly configured copy of W5WC's HPSDR version of PowerSDR.  Bingo, you have an exceptionally nice direct digital conversion receiver.

73,

Dan N4XWE




________________________________
 From: 101science <101science at gmail.com>
To: "hpsdr at lists.openhpsdr.org" <hpsdr at lists.openhpsdr.org> 
Sent: Wednesday, October 24, 2012 2:21 PM
Subject: [hpsdr] TAPR Hermes Arrived Today
 
***** High Performance Software Defined Radio Discussion List *****

Got my board in Georgia today. Plan to wait until my ANAN-10 arrives though before I power it up as there seems to be a lot of confusion over what needs to be done to the board to make it operational stand alone. 
Larry K4LED

Sent from my iPod

_______________________________________________
HPSDR Discussion List
To post msg: hpsdr at openhpsdr.org
Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
HPSDR web page: http://openhpsdr.org
Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20121024/3da66806/attachment-0003.htm>