[hpsdr] HPSDR tailored into 19" rack

[Georg Prinz]

Hello Joe, hello all,

I loaded some photos without comments into directory "hpsder_boxed" on
www.qsl.net/dl2kp, how I tailored my HPSDR with three receivers into a
19" rack.

73, Georg



Am Sonntag, den 20.02.2011, 08:40 -0700 schrieb Joe Martin K5SO:
> ***** High Performance Software Defined Radio Discussion List *****
> 
> 
> 
> New information:
> 
> 1)  I am able to restore operation of the Metis board by using a USB- 
> Blaster cable (ASIC Terasic Blaster cable) by attaching the blaster  
> cable onto the JTAG header and targeting the Metis.sof file to load  
> code into the Metis FPGA directly through the JTAG header with the  
> Quartus II Programmer in JTAG mode and with JP1 in place on the Metis  
> board.
> 
> 2)  After restoring operation, the board will operate normally if you  
> remove JP1 while the board is running until the Metis board is power  
> cycled.  Upon a power cycling of the Atlas bus the Metis board does  
> not come up (no status LEDs lit, only the four power supply LEDs come  
> on).
> 
> This Metis  board is unable to come up in a normal manner once power  
> has been removed from it.
> 
> Hints?
> 
> 73,  Joe K5SO
> 
> 
> 
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/