[hpsdr] Fwd: Re: No dual receiver on Tranverter IF Band???

[Brian D]

Bill Diaz <william.diaz at comcast.net> wrote:

> Clyde, Not sure I am following you, especially the EXT1/RX2 reference.
> EXT1 is associated with RX1, not RX2.  If you are using a splitter to
> share an antenna for EXT1 and RX2 then the EXT1/RX2 reference would make
> sense to me.
> 
> Your statement : This is a bug -- you should be able to have dual
> receivers on 10m AND use it as your Tranceiver IF.  Please put this on the
> "to be fixed" list! You can only select ONLY 1 external receiver antenna
> source (EXT1, EXT2 or XVTR) for RX1 on a given band. 

The XVTR selection should be switched by the selection of band to be VHF+
and revert to the EXT position selected when the "HF" bands are selected.


>  See drawing below.
> This is by design, otherwise you could have multiple receive antennas
> connected to RX1 at the same time.
> 
> Note:  I verified PowerSDR 3.1.5 external antenna selection operates as
> intended using my ANAN-100D and 2 receive antennas.
> 
This is additional to the bug which does/does not enable/disable the HF PA
whwn switching between a XVTR band and an HF band.


Between them makes it virtually imnpossible to use the rig on " Metres via
my transverter and on the HF bands without considerable reconfiguring of the
settings. 

-- 
Brian D
G3VGZ

 1387060225.0