[hpsdr] [apache-labs] Re: Angelia_v2.5 and PowerSDR_mRX_PS_RA v3.2.8 (1Feb2014)

[Joe Martin K5SO]

All, 

As the latest versions of Angelia code which support PureSIgnal are based on Hermes code, they all contain the particular LPF switch points that the Hermes code does.  Some time back (I forget when exactly) Abhi determined that the ANAN-100D needs different switch points from Hermes when 12m operations are used.  I completely forgot about that when I created the PureSignal versions of code for Angelia and this improper switching exists in the current Angelia_v2.5 firmware, unfortunately. 

I will make the appropriate correction in a new Angelia_v2.6 firmware release immediately.   Hopefully that will cure this low power problem with the ANAN-100D on 12m.   Not having ANAN-100D here to test with is a distinct disadvantage when trying to write firmware code it, I must rely on others to test the firmware that relates to anything beyond the Angelia board itself in the ANAN-100D; I apologize for the inconvenience my coding oversight has caused on this issue. 

73,  Joe K5SO

On Feb 3, 2014, at 12:20 PM, mstangelo at comcast.net wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> Paul,
> 
> I'm weary about downgrading code. The programmer locks up and I have to use the bootloader.
> 
> Maybe one of the developers cold examine the code to see if there are any differences in the LPF selection.
> 
> Abhi,
> 
> Can you check your ANAN-100D with Angelia_v2.5 and PowerSDR_mRX_PS_RA v3.2.8 (1Feb2014?
> 
> Mike N2MS
> ----- Original Message -----a
> From: Paul Baron <paul.baron at uwclub.net>
> To: apache-labs at yahoogroups.com.
> Sent: Mon, 03 Feb 2014 19:14:18 -0000 (UTC)
> Subject: RE: [apache-labs] Re: [hpsdr] Angelia_v2.5 and PowerSDR_mRX_PS_RA v3.2.8 (1Feb2014)
> 
> Hi Paul,
> 
> 
> 
> Originally when I got my Anan 100D the PA Calibrated was ok but after
> upgrades it is now showing low power, but I couldn't point to any
> 
> 
> 
> Particular upgrade. Maybe I should revert back to 1.9 firmware and the
> original software and try that when I get the time.
> 
> 
> 
> Regards
> 
> 
> 
> Paul  G2PB 
>