[hpsdr] Pennylane no output

[Jan Svabenik]

Hi Georg,

Thank you for the reply. 
Sparepart is already ordered - I will replace both of the amps next week. I think after it will be ok again.

Have a great weekend-

73

Jan



-----Original Message-----
From: Georg Prinz [mailto:getpri at t-online.de] 
Sent: Freitag, 11. Juli 2014 21:30
To: Jan Svabenik
Cc: hpsdr at openhpsdr.org
Subject: Re: [hpsdr] Pennylane no output

Hello Jan,

I did have the same problem with penylane. I couldn´t figure out the reason. There was no obvious motive for the failure. After replacing the amplifier everything was ok. No problem anymore.

73, Georg, dl2kp


Am Freitag, den 11.07.2014, 10:29 +0000 schrieb Jan Svabenik:
> ***** High Performance Software Defined Radio Discussion List *****
> 
> Hi!
> 
> Today during transmitting my output from penny dropped to 0. Since then output stays 0.
> The RF genereation in general seem to work - I suspect that the Amplifier stage with the OPA2674s  failed - they get very very hot.
> Had anybody already a similiar problem?
> 
> Thanks
> 
> Jan
> 
> Jan Svabenik
> Oberdörfli 12a
> 9215 Schönenberg an der Thur
> 
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: 
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/