[hpsdr] New Hermes code available

[Phil Harman]

Hi Erik,

You are correct in that you can customise the LPF settings in PowerSDR but 
in automatic mode the selection frequencies for Alex and ANAN are different.

73 Phil...VK6PH



-----Original Message----- 
From: Erik van Maanen
Sent: Friday, March 21, 2014 8:09 PM
To: phil at pharman.org
Cc: hpsdr at openhpsdr.org
Subject: [hpsdr] New Hermes code available

Ok Phil thanks for the clarification.
I discovered a 2.6b on the apache website so I will use that one for
now, I assume thats the right one.
I  always thought that the logic was switched from the application
program such as powersdr because you can select the different
configurations (alex / anan) there.

73 Erik PA3DES

Phil Harman schreef op 21-3-2014 2:25:
> Erik,
>
> Yes, Hermes and the ANAN-10 did use the same code but don't anymore.
>
> The Apache and Alex Low Pass Filters have different characteristics which
> means the switching logic is different between the two radios.
>
> If you want to use V2.5a on your ANAN-10 then go ahead. But if you find
> low power out on some bands then don't be surprised.
>
> 73 Phil...VK6PH
>
>
>
>
>> Hermes and Anan-10 always used the same firmware, you set the logic in
>> powersdr, is there something different with this release.
>> How about version 2.5a can I run this on my anan-10 ?
>>
>> Erik PA3DES
>>
>>
>
>


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com


 1395404703.0