[hpsdr] Penelope no modulation

[Scott Cowling]

Hi Gary,

Not sure where you read that you need to remove JP10 and JP11, but they 
need to be installed for the Penelope CODEC to work properly.

See page 4 of the Penelope manual.

73,
Scotty WA2DFI



On 1/14/2016 3:40 AM, Gary Beech wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
>
>
> Hi All,
>
> I am having trouble with my Penelope Transmitter firmware version 1.8.
>
> Running PowerSDR OpenHPSDR mRX PS v3.3.6 (11/16/15)
>
> I have removed jumpers J10 and J11 ( these are the I2C jumpers which if
> left in I read upset the CODEC)
>
> I am using a Atlas mother board with
>
> Excalibur reference,
>
> Mercury Receiver version 3.4 firmware
>
> Métis  Ethernet interface  version 3.0 firmware.
>
> These are all working well.
>
> When I operate the MOX button I have no modulation, I have confirmed the
> audio is at the Aud. jumper.
>
> Any ideas.
>
> Thank you
>
> 73 Gary vk2kyp
>
> <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
> 	This email has been sent from a virus-free computer protected by Avast.
> www.avast.com
> <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
>
>
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>




 1452825928.0