[hpsdr] Wiring/connecting a footswitch to the 200D

[List Mail]

Dick, I just used the front panel “Mic” TRS jack for my foot switch connection, after setting the Ring for PTT in settings, of course.

73,
Luke VK3HJ
ANAN 200D

From: W1FYI 
Sent: Tuesday, September 26, 2017 10:04 PM
To: hpsdr at lists.openhpsdr.org 
Subject: [hpsdr] Wiring/connecting a footswitch to the 200D

***** High Performance Software Defined Radio Discussion List *****




--------------------------------------------------------------------------------

I have a 200D and like it a lot. I want to run a footswitch and am concerned about making a mistake but see the pins (PTT input 3v) 13 and either 21 or 25 (analog ground) appear to be the correct to use to key the transmitter through PTT input for the footswitch. Please confirm that I would be correct in doing this way. I have the extender board also. Can I just use the TRS input for the key in the front or is the RS-232 the better way?

 

Thanks and 73,

 

Dick  

W1FYI

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20170926/fceeffc2/attachment.html>