[hpsdr] Pure Signal 2

[Richard Grubb]

Hi Scott,

Thank you. That answers my questions. I am not sure why that page did 
not come up in my searches. A great Thank You to all the programmers of 
Pure Signal.

One minor point I have not seen in any of the documentation of Pure 
Signal or PowerSDR is that it seems to be necessary to set Duplex 
receiver mode. Perhaps obvious in retrospect but my initial assumption 
was that Pure Signal itself would make any setup necessary for the 
receiver to accept the feedback signal.

73, Dick
W0QM/G3FNL

------ Original Message ------
From: "Scott Traurig" <scott.traurig at gmail.com>
To: "Richard Grubb" <richard.n.grubb at comcast.net>
Cc: "hpsdr" <hpsdr at lists.openhpsdr.org>
Sent: 2/13/2018 6:47:22 PM
Subject: Re: [hpsdr] Pure Signal 2

>***** High Performance Software Defined Radio Discussion List *****
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20180214/fe66a21f/attachment.html>