<div>I came into a spool of thermalcouple wire the same time I was building my passive solar room. I had the bright idea of putting thermal couples in the rock bed to measure the stored heat. I didn't want a mechanical bond so I came up with an idea to weld the ends. I charge up a big cap 30,000 ufd, if I remember, to 30 volts then make a carbon rod from a drafting pencil lead ( remember before cad schematics) A couple clip leads one to the carbon rod and the other to behind the joint to be welded. I twist the ends and strike an arc. There is enough energy in the cap to do a nice weld. </div>  <div>I suppose a current limited power supply would work but you still need toe carbon rod to control the slag blob from exploding.</div>  <div> </div>  <div>Be careful with digital step attenuators. Sometimes the control signals can cross talk to the rf channel causing clicks as it steps up and down. I spend many hours trying to make the worlds best
 noise blanker that just replaced the noise with a click. </div>  <div>I think this isolation number is included in the data sheet.     frank</div>