<div>Hi everyone,</div>  <div> </div>  <div>You can call me a newbie to SDR. I just purchased the ATLAS kit from TAPR to get on the bandwagon. Since I consider myself 'old school' in electronics and have little experience in SDR except the concept. I had a few questions as I couldn't find the answers on Wiki.</div>  <div> </div>  <div>1: I've seen the ATLAS pinouts and the connections JANUS and OZY board to the backplane. What is the protocol being used for communication on the backplane? Where do I find this information?</div>  <div> </div>  <div>2: The MERCURY board shows a 0-30 Mhz input and output, but is only refered to as a Direct Sampling Receiver board. With the block diagram showing the 4 boards I was assuming that Mercury was an IF board for both TX and RX. Is it just a receiver?</div>  <div> </div>  <div>3: Is there a consideration of having a IF switch board for the use of transverters? </div>  <div> </div>  <div>Any
 information to get me on the same page would help.</div>  <div> </div>  <div>Chris N0TTW</div><p>
                <hr size=1>Yahoo! Messenger with Voice. <a href="http://us.rd.yahoo.com/mail_us/taglines/postman1/*http://us.rd.yahoo.com/evt=39663/*http://voice.yahoo.com">Make PC-to-Phone Calls</a> to the US (and 30+ countries) for 2¢/min or less.