<div>I have a couple 8901s kicking around that came as samples. The problem with them is you are stuck with ring configuration. It will give you IP3 of near 40 dB with a lot of lo drive.</div>  <div>Building a good lo amplifier is a no brainer. Square wave drive at that voltage is a different issue.</div>  <div>My RA6830 uses a SD5000 in a ring and the first roofing filter falls apart before the mixer. </div>  <div>The HP8640B at full bore just starts compressing the mixer. The gates have low C so two devices could be stacked to reduce RDS on.</div>  <div>I have not played with H mode yet but would like to stick one in the second mixer of my hot rod. The second mixer in a standard dual conversion is usually the weak link for close in dynamic range problems. I like the H mode because the fets are referenced to ground.</div>  <div>I bet better transformer design and bigger FETs would make for impressive results. I have a few CP666s that would be cool to try. Work gets in the
 way of so many cool projects.</div>  <div>Building a house makes it even more interesting. frank wa1gfz</div>