<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META HTTP-EQUIV="Content-Type" CONTENT="text/html; charset=us-ascii">
<META content="MSHTML 6.00.2900.3059" name=GENERATOR></HEAD>
<BODY>
<DIV><SPAN class=859471718-29052007><FONT face=Arial
size=2>Team:</FONT></SPAN></DIV>
<DIV><SPAN class=859471718-29052007><FONT face=Arial size=2>I have assembled,
programmed, and attached OZY and JANUS to a just built SDR1000 single
board clone. This is however a painful way to start up with all unknown
hardware. After running Initozy.bat I noticed
that Ozy has LED D12 on, LED D10 flashing, and LEDs D7 and D8 on. This
does not match the combination that is described on other's boards. Does
anyone have an idea what D7 and D8 on may be indicating? BTW, the manual
tells you which jumpers to set but leaves the zero ohm resistor settings
undefined. These zero ohm jumpers also change from picture to
picture. What positions were these installed in on the production
boards? I have taken my best guess by looking through the
schematics. </FONT></SPAN></DIV>
<DIV><SPAN class=859471718-29052007><FONT face=Arial
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=859471718-29052007><FONT face=Arial size=2>Ozy and
Janus seem to be working and the relays on the SDR1000 are working
correctly, but no signal to PowerSDR yet. Getting
there.</FONT></SPAN></DIV>
<DIV><SPAN class=859471718-29052007><FONT face=Arial size=2>Thanks for any
assistance you can give and for the great results to date. </FONT></SPAN></DIV>
<DIV><SPAN class=859471718-29052007><FONT face=Arial
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=859471718-29052007><FONT face=Arial size=2>Tommy Hollingsworth
KV5T</FONT></SPAN></DIV>
<DIV><SPAN class=859471718-29052007><FONT face=Arial
size=2></FONT></SPAN> </DIV></BODY></HTML>