<div>Hi All,</div>  <div>I was just looking at the A/D pc board layout. At work we usuall put a blob ot thermal epoxy under hot parts to sink heat to a thermal plane on the surface of the pc board. Usually the part is mounted over a small hole so the epoxy can be injected under the part die.</div>  <div>You guys building your own boards may consider a thermal transfer pad under the part to cool it down a bit.</div>  <div>The part is rated to work at 70 degree C ambient but hot parts die young.</div>  <div>I think I will glue a hunk of copper to the top of my part. frank </div>