Last night, I finally got around to hooking up a GPSDO (Thunderbolt) to Atlas.  My immediate goal is to get precision sampling (frequency) from Janus.  I'm not a HW engineer, and my interface from the Thunderbolt is pretty naive: terminated with 50ohms, then coupled through a capacitor to a voltage divider between 3.3V and GND into C16.  I don't have a scope, so if anyone has a suggestion of proper components for an interface which gets the levels right from a ~10dBm/50ohm Tbolt input, please share.<br>
<br>Using PowerSDR PennyMerge, if I have Penny in the system and select Atlas for 10MHz, it seems to work correctly. Sampling frequency is spot on as far as I could easily measure, though there are occasional short drop-outs on the audio which lead me to believe the clock is marginal.  With Penny not installed, it does not work: Janus seems to revert to it's own oscillator rather than lock to the 10MHz, off by ~100ppm.  Not clear to me why this would be, unless just having Penny further down the bus is providing better termination for the signal.  I have not played with slot location any further.<br>
<br>If anyone has gone through this exercise or has suggestions to "do it right", please advise.  I suppose I could put something like a Clock Block in front of it to drive it with a stiffer square wave, but looking for a minimal robust solution.<br>
<br>--bruce w1bw<br><br>