<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;"><DIV>GM all,</DIV>
<DIV>Well Phil reports I may have a bad relay on my board making it unable to select the pad on the input. Last night I looked under the scope and measured the pad. 50 ohms on each side to ground so it is a pad. I was pretty tired but need to look again today. </DIV>
<DIV>I'm using all linear power supplies so things are pretty quiet. Look at CTRSurplus on ebay. I bet you can get 3 linears for under $40.</DIV>
<DIV>I was tricked a couple times changing bands and modes when the AGC-T level changed on its own. Keep an eye on it if the radio goes quiet.</DIV>
<DIV>My CPU horse power is in the 13% range so not much work going on.</DIV>
<DIV>So far under poor conditions Mercury seems to work better than my QSD set up.</DIV>
<DIV>My Racal RA6830 could pull an AM signal out while the QSD just produced noise. Mercury seems at least equal to the Racal so far.</DIV>
<DIV>Leaving speakers connected to Janus made me feel quite stupid. frank    </DIV></td></tr></table>