<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;"><DIV>hi All,</DIV>
<DIV>I found the 5 MHz reference coming out of my Racal RA6830 about the cleanest in my shack. HP8640B had some spurs out around 20 KHz that was messing up the numbers.</DIV>
<DIV>I drove Mercury with about -22 dBM with the preamp on. It was in cw mode with 500 Hz. bandwidth. 500 Hz bandwidth correction factor is -27 dB so it was added to the levels I measured. It looks quite good and didn't notice any difference changing to Penny as a clock source. </DIV>
<DIV>The Final numbers</DIV>
<DIV>5.0000 MHz           0dB</DIV>
<DIV>4.9999                  -27.3</DIV>
<DIV>4.9998                  -33.7</DIV>
<DIV>4.9997                  -62.4</DIV>
<DIV>4.9996                  -126</DIV>
<DIV>4.9995                 -129</DIV>
<DIV>4.999                   -139 </DIV>
<DIV>4.998                   -141</DIV>
<DIV>4.997                   -142</DIV>
<DIV>4.995                   -144</DIV>
<DIV>4.990                   -145</DIV>
<DIV>4.980                   -144</DIV>
<DIV>I don't think anyone can complain with these numbers. I need to look at the 8640Bs to make sure there is no BB crud coming out of them causing the noises I heard yesterday measuring dynamic range. My Analog RX would have stripped them out with the roofing filter. I did measure the phase noise with the 8640B set at 5 MHz but as expected the levels were a bit worse. Frank WA1GFZ</DIV></td></tr></table>