<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;"><DIV>Hi All,</DIV>
<DIV>I'm conviced the A/D is hot because the heat is trapped near the part. The Data sheet says most of the heat comes out the bottom. I'm thinking of soldering a brass flat heat screw to the thermal pad and then thread on some sort of removable heatsink just in case there is a need to get at the back side of the board. Then I can just keep increasing the surface area of the heat sink until it cools the part better. 1.25 watts I would want about 3 square inches of surface area to keep it safe. That would be 6 inches if you count both sides. Rule of thumb I use is 130 degrees C per watt per square inch.  Heat likes to rise so it will have to go up and maybe bent in an L. Or we could just turn it upside down....</DIV>
<DIV>Any ideas out there. It sure makes sense to mount the A/D away from the Atlas interface full of digital noise but I think we are a bit too close to the top edge. Summer conditions a while away but you VK and ZL guys have the heat now. frank</DIV></td></tr></table>