<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;"><DIV id=yiv676501531>
<DIV>Hi all,</DIV>
<DIV>I did a little testing at 5 and 10 MHz. 10 MHz I used the reference from my Cubic R2307 and 5 MHz. the same Racal source. The phase noise hits -130 dBc at abut 500 Hz which is very good. I do notice one thing that may be new or I never noticed it before.</DIV>
<DIV>When you look at the broadband noise floor around 10 MHz any signal above -40 dBM raises the BB noise floor. Suspecting it may be the source I went back to the Racal oscillator at 5 MHz. The broadband noise floor increased when the input signal was above   -20 dBM. ( I tested 2.3 at -17 dBM input) You have to go out 100 KHz or so to see it becasue close in things look great. The spectrum seems to look different at 5 MHz Close in looks better but far out looks worse.</DIV>
<DIV>The MDS is about -135 dBM so that is 115 dB of range.  I then did a dynamic range check on 75 meters. At 5 KHz spacing I measure 95 dB and at 20 KHz 103 dB. I have not checked dynamic range since 2.1 when I got 100 dB at 20 KHz spacing. I didn't check closer in because of all the weird ticking from phase noise close in. </DIV>
<DIV>So close in thngs look good but not sure about the BB noise floor increasing which could be due to my source. </DIV>
<DIV>One other thing I seem to hear random popping about every 2 seconds when there is a strong carrier present. I don't remember hearing this with 2.3. </DIV>
<DIV>I think I have a combination of things going on. My test equipment is running out of steam, I'm getting more critical and maybe going through a learning curve on how to test this thing.</DIV>
<DIV>I'n not sure if the BB noise increase was also in other versions because I never looked that far off CF while checking phase noise. I will in the future. </DIV>
<DIV>Frank WA1GFZ</DIV></DIV></td></tr></table>