Hi all,<br><br>I seem to have one of the Mercury boards with soldering issues on the ADC heatpad.<br>11 of the 34 holes show no solder flow at all (most are around the edges with 2 in the middle of the pad). I have not hooked it up yet to check the temperature but I suspect this may be enough of a sign that I'd want to reflow the ADC heat pad anyway.<br>
<br>What would be the best method to make sure I've got a good contact between the board and chip and that I have have all the heat pipes soldered through, those holes are pretty small! Unfortunately all I have at my disposal for this work is a pencil iron.<br>
<br>Or is the experience of the group such that there shouldn't be a problem and that I should not worry about it?<br><br>BTW - This is no reflection on the folks at TAPR or anyone else, I completely understand this is an experimenters kit and have no problem fixing any issues I may encounter on my own. The folks at TAPR and the people who designed and made this equipment possible are tops in my book.<br>
<br>73!<br><br>Todd M0GLO<br><br><br>