<h3>The  <span class="mw-headline">Janus Firmware Upgrade at the Wiki Quick Startup Guide is wrong at line 5:</span></h3><br><br>
<ol><li> Power off your Atlas board.
</li><li> Remove all boards except Ozy.
</li><li> Make sure your Ozy board is placed one slot away from the power connector on Atlas.
</li><li> Fit a jumper on Janus to the JP12 header pins marked <i>LAST JTAG</i> located at the bottom left of the board just above the Atlas connector.
</li><li> Install Penelope in the slot between Ozy and the power connector.
</li><li> Power up the Atlas board.
</li><li> Run the batch file Program-Janus-EPM240T100.bat, select which
version of the Altera Quartus programmer code you are using and the
Janus firmware version you wish to load and look at the output, there
should be no errors. <i>Do not interrupt the loading process; it takes approximately 5 seconds to load the EPM240T100.</i>
</li><li> Power off your Atlas board.
</li><li> Remove the jumper on JP12.
</li><li> Continue with additional firmware upgrades or read restarting after firmware upgrade below.
</li></ol>73 Luis NZ5U<br>