Hi Phil, <div><br><div>"50c" you mean 50 cents as in any inexpensive  12v relay? I've been checking prices of coax relays and their not cheap, thats for sure..  <div><br></div><div>Thx for the info</div><div>
<br></div><div>Jim</div><div><br><div class="gmail_quote">On Tue, Mar 16, 2010 at 9:53 PM, Phil Harman <span dir="ltr"><<a href="mailto:phil@pharman.org">phil@pharman.org</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">
<div class="im">      I read up on<br>
> the DJ8AY TR switch but was wondering whether other home-brew techniques<br>
> were being used while waiting for alex, or, are people just<br>
> using separate antennas for  TX and TX.<br>
><br>
<br>
</div>I'm using a 50c relay operated from the open drain FET on Penny.<br>
<div class="im"><br>
> I notice people are using duplex using the KK (which I have not had chance<br>
> to install yet).   How are you connecting the antenna and protect the<br>
> receive input?<br>
><br>
<br>
</div>The relay I'm using has sufficient isolation to enable full duplex<br>
operation at 100w.  I have also used separate Tx and Rx antennas - if you<br>
keep the Rx signal level below the point that the ADC overload does not<br>
light in KK then you will be fine.<br>
<div class="im"><br>
<br>
<br>
> I am getting ready to build pennywhistle here and  I assume I need to wait<br>
> for alex before using the pennywhistle.   I am wondering however if the<br>
> pennywhistle or higher power amp can used while in this duplex mode?<br>
<br>
</div>Yes, I use 100w without any problems.<br>
<div class="im"><br>
<br>
<br>
> There<br>
> does not seem to be much info on how Alex will work with break-in keying<br>
> so<br>
> I am also wondering whether this was tested and how it will work.<br>
><br>
<br>
</div>The TR relay on Alex was chosen to work full break-in, I've tested it and<br>
it works fine.<br>
<br>
<br>
73's Phil...VK6APH<br>
<br>
</blockquote></div><br></div></div></div>