Phil,<br><br>The more I think about it, I wonder if it would make more sense for me to plan on using the Atlas architecture rather than the HERMES board as the basis of the DSDR. I assume the Atlas backplane can handle a large number of concurrent RX/TX baseband channels? If I took this path then I would combine low-level RX/TX (Mercury/Penelope) DSP functions into a single FPGA and put an FO transceiver on the board. The endpoint RX/TX modules would be the same as I envisioned for HERMES. So, the rig would comprise a PS, Atlas, Ozy I/II and my board. The antenna side would either be a combo RX/TX, or discrete RX and TX boards. At a later point, the lessons of HERMES could be applied to a single board derivative that could also interface the the FO RX/TX modules.<br>
<br>The actual FO link speed would be 20 x 122.88MHz = 2.4576Gbps. With a 97% payload efficiency I am left with 2.384Gbps, where 1.966Gbps is for DDC/DUC data and the rest is for ancillary data. I like this because it simplifies the clocking schemes. If a disciplined 10MHz reference is available on the Atlas bus, then this reference will propagate to the RX/TX modules via the embedded FO clock. <br>
<br>Is this really all that appealing to anyone? I don't know if it is the challenge or the end result that is driving me.<br><br>-Ray<br>Georgetown, TX<br><br><br><br><div class="gmail_quote">On Fri, Jun 18, 2010 at 8:55 PM, Phil Harman <span dir="ltr"><<a href="mailto:phil@pharman.org">phil@pharman.org</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">





<div bgcolor="#ffffff">
<div><font face="Arial" size="2">Hi Ray,</font></div>
<div><font face="Arial" size="2"></font> </div>
<div><font face="Arial" size="2">You are quite correct. The receiver board (Mercury) 
incorporates a Digital Down Converter that takes the 1.966Gbps ADC data at 16 
bits per sample and reduces it to 48/96/192ksps at 24 bits per sample.  
This slower data is passed over the Atlas bus to either an Ozy board (USB 
interface to the PC) or shortly an OzyII  board (Gigabit 
Ethernet).</font></div>
<div><font face="Arial" size="2"></font> </div>
<div><font face="Arial" size="2">Hermes does the same except the functions of 
Mercury and Ozy are combined on the one board.</font></div>
<div><font face="Arial" size="2"></font> </div>
<div><font face="Arial" size="2">73's Phil...VK6APH </font></div><br></div></blockquote></div><br>