<html dir="ltr"><head>
<meta http-equiv="Content-Type" content="text/html; charset=iso-8859-1">
<style id="owaTempEditStyle"></style><style title="owaParaStyle"><!--P {
MARGIN-TOP: 0px; MARGIN-BOTTOM: 0px
}
--></style>
</head>
<body ocsi="x">
<div style="FONT-FAMILY: Tahoma; DIRECTION: ltr; COLOR: #000000; FONT-SIZE: 13px">
<div></div>
<div dir="ltr"><font color="#000000" size="2" face="Tahoma">Hi, everyone --</font></div>
<div dir="ltr"><font size="2" face="tahoma"></font> </div>
<div dir="ltr"><font size="2" face="tahoma">I got Penelope working on SSB tonight, thanks to a search of the list archive. The information below was posted to the list back in January, by Bill KD5TFD. Is it possible to get this information added to (1) the
Penelope manual, and (2) the Penelope troubleshooting wiki page? I think it would be a great help to those who have the Penelope / Magister combination, and who may not think to look at the Magister docs. (In my case, Magister had been working fine for a
few months, so I didn't think to suspect it when Penny didn't work.)</font></div>
<div dir="ltr"><font size="2" face="tahoma"></font> </div>
<div dir="ltr"><font size="2" face="tahoma">I'd be glad to add the info to the wiki, if granted access, but I don't have the software to update the PDF manual.</font></div>
<div dir="ltr"><font size="2" face="tahoma"></font> </div>
<div dir="ltr"><font size="2" face="tahoma">Thanks and 73,</font></div>
<div dir="ltr"><font size="2">-<font face="tahoma">Ed- AB8OJ</font></font></div>
<div dir="ltr"><font size="2" face="tahoma"></font> </div>
<div dir="ltr"><font size="2" face="tahoma">Text of message:</font></div>
<div dir="ltr"><font size="2" face="tahoma"></font> </div>
<div dir="ltr">The mic is not working because the I2C bus from Magister is not <br>
connected to the Atlas bus by default. This causes the <br>
initialization of the codec on Penelope to fail, and no <br>
initialization means no mic.<br>
<br>
Easy to fix - shorting blocks need to be added to two jumpers on <br>
Magister On my Rev A board (pre production, but I believe the <br>
production boards are pretty much the same) the jumpers are to the <br>
left of U1 when looking at the top of the board with the Atlas <br>
connector to the bottom. The silkscreen says I2C to Atlas and the <br>
jumpers are labeled SCL and SDA. Horizontally adjacent pins should <br>
be shorted by a shorting block. If you don't have shorting blocks on <br>
hand I'd suggest scrounging some off old PC cards.<br>
<br>
Cheers,<br>
<br>
Bill (kd5tfd)<br>
</div>
</div>
</body>
</html>