I just did my first SMT soldering job (was a lot easier than I expected once I got the necessary equipment).  However...<br><br>After I attached the components but before I attached the slots I thought I did a fairly good test of J20 for any shorts.  However, now that everything's attached I'm noticing a 275 ohm separation between +5v and ground.<br>

<br>I don't see any obvious solder outside of their pads, but with all the rosin floating around I could be missing something.  This is a bit higher than I'd expect for a simple short though, is this part of the design of the board?<br>