Thanks for the replies, I think the takeaway was "this isn't normal for the Atlas board, you can probably get away with an additional 18ma drain, but this probably isn't a good start for a thousand-dollar radio".  So I've decided to start over again with a second kit that I had squirrelled away.<br>

<br>However, this one has a bend/broken pin on the Molex connector.  As far as I can tell it's one of the ground pins.  Considering that I seem to have spare ground pins, is there any potential downside in using the damaged connector, rather than trying to desolder the one from the first attempt or ordering another one from Mouser?<br>

<br><div class="gmail_quote">On Sat, Nov 6, 2010 at 7:28 PM, Erik Anderson <span dir="ltr"><<a href="mailto:erikba@odysseus.anderson.name">erikba@odysseus.anderson.name</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">

I just did my first SMT soldering job (was a lot easier than I expected once I got the necessary equipment).  However...<br><br>After I attached the components but before I attached the slots I thought I did a fairly good test of J20 for any shorts.  However, now that everything's attached I'm noticing a 275 ohm separation between +5v and ground.<br>


<br>I don't see any obvious solder outside of their pads, but with all the rosin floating around I could be missing something.  This is a bit higher than I'd expect for a simple short though, is this part of the design of the board?<br>


</blockquote></div><br>