Hello<div><br></div><div>Duane W5PNM asked for assistance on Teamspeak last night in diagnosing a suspected problem with his Penelope. He was looking for information on the input and output voltages at Penelope's output device (OPA2874 Op Amp).  </div>
<div><br></div><div>Here are some measurements on my Penelope. </div><div><br></div><div>Setup:</div><div><br></div><div>Software: K5SO PWSDR 1.19.3.5 diversity20</div><div>Frequency 7.010 Mhz.</div><div>Power Output measured at 500 mW into 50 ohm load</div>
<div><br></div><div>Voltage measurement at JP2 (Input to T1) 295mV RMS</div><div>Voltage measurement at 50 ohm load 5.10V RMS</div><div><br></div><div>Measurements were taken with an Agilent Oscilloscope MSO-X 2024A.</div>
<div><br></div><div>I have uploaded a screenshot of the scope at Hamsdr.com in my personal files section.</div><div><br></div><div><a href="http://www.hamsdr.com/PersonalDirectory.aspx?did=44">http://www.hamsdr.com/PersonalDirectory.aspx?did=44</a></div>
<div><br></div><div>As is usual in most experiments, one thing leads to something unexpected......</div><div><br></div><div>The input waveform shows a definite 122 Mhz ripple.  I am not sure if it really there ....is it an artifact a poor scope connection or is it leakage from the clock connection between my two mercury cards (used for synchronization for diversity reception). More investigation is needed.</div>
<div><br></div><div>73</div><div><br></div><div>Rick ve3mm</div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div>