File update:<div><br></div><div>The replacement .bmp file with the proper input and output waveforms for Penelope are now here.  No more ripple on the input. Scope connection improved. Used direct connection with coax and suitable connector to JP2.</div>
<div><br></div><div><a href="http://www.hamsdr.com/ManageFiles.aspx">http://www.hamsdr.com/ManageFiles.aspx</a></div><div><br></div><div>73</div><div><br></div><div>Rick ve3mm<br><br><div class="gmail_quote">---------- Forwarded message ----------<br>
From: <b class="gmail_sendername">Rick ve3mm</b> <span dir="ltr"><<a href="mailto:richardstasiak@gmail.com">richardstasiak@gmail.com</a>></span><br>Date: Sat, Sep 3, 2011 at 6:30 PM<br>Subject: Penelope Input and Output Voltages and Waveforms<br>
To: <a href="mailto:hpsdr@lists.openhpsdr.org">hpsdr@lists.openhpsdr.org</a><br><br><br>Hello<div><br></div><div>Duane W5PNM asked for assistance on Teamspeak last night in diagnosing a suspected problem with his Penelope. He was looking for information on the input and output voltages at Penelope's output device (OPA2874 Op Amp).  </div>

<div><br></div><div>Here are some measurements on my Penelope. </div><div><br></div><div>Setup:</div><div><br></div><div>Software: K5SO PWSDR 1.19.3.5 diversity20</div><div>Frequency 7.010 Mhz.</div><div>Power Output measured at 500 mW into 50 ohm load</div>

<div><br></div><div>Voltage measurement at JP2 (Input to T1) 295mV RMS</div><div>Voltage measurement at 50 ohm load 5.10V RMS</div><div><br></div><div>Measurements were taken with an Agilent Oscilloscope MSO-X 2024A.</div>

<div><br></div><div>I have uploaded a screenshot of the scope at Hamsdr.com in my personal files section.</div><div><br></div><div><a href="http://www.hamsdr.com/PersonalDirectory.aspx?did=44" target="_blank">http://www.hamsdr.com/PersonalDirectory.aspx?did=44</a></div>

<div><br></div><div>As is usual in most experiments, one thing leads to something unexpected......</div><div><br></div><div>The input waveform shows a definite 122 Mhz ripple.  I am not sure if it really there ....is it an artifact a poor scope connection or is it leakage from the clock connection between my two mercury cards (used for synchronization for diversity reception). More investigation is needed.</div>

<div><br></div><div>73</div><div><br></div><font color="#888888"><div>Rick ve3mm</div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div>
</font></div><br></div>