<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;"><DIV id=yiv219987865>
<TABLE id=yiv219987865bodyDrftID class=yiv219987865 border=0 cellSpacing=0 cellPadding=0>
<TBODY>
<TR>
<TD style="FONT-FAMILY: arial; FONT-SIZE: 10pt" id=yiv219987865drftMsgContent>
<DIV>Rather than argue about where to produce the boards argue the expected cost of materials. Labor at $2/hr vs $26/hr will not change the cost that much if this design has been done for automated pick and place, soldering, test, and firmware load. Remember this is not a mass produced product in the sense of an iPod, it is simply a board with SMT parts on it.</DIV>
<DIV></DIV>
<DIV>Therefore, focus on the Bill of Materials cost. I have not seen a schematic since the original post and at that time the cost would have been similar to the Mercury board alone. A complete SDR solution with Hermes should be cheaper. What has happen to drive cost to double if not triple that of Mercury? </DIV>
<DIV></DIV>
<DIV></DIV>
<DIV> </DIV>
<DIV>Do we need a new effort for a Hermes Lite to drive cost back down? I would be happy to support such an effort.</DIV>
<DIV></DIV>
<DIV></DIV>
<DIV> </DIV>
<DIV>Finally, as an "open" effort I also see no issue in permitting anyone to produce the product anywhere as long as that person or group licenses "as-is" with no implied support and it is non-commercial. A small license fee may be necessary. Remember, we are a community of amateur radio operators and experimenters. So, let's have fun!</DIV>
<DIV></DIV>
<DIV></DIV>
<DIV> </DIV>
<DIV>Jim, N1<SPAN><SPAN><SPAN>KWZ</SPAN></SPAN></SPAN><BR><BR></DIV></TD></TR></TBODY></TABLE></DIV></td></tr></table>