Looking thru the rear window:<br><br>From TAPR: Ozy, Atlas, LPU, Metis, Pennylane and Mercury=  $ 1,358 + shipping (for TAPR members)<br><br>Now let's look at the Wiki page for Hermes:<br><br> <br><br><ul><li>Uninterrupted coverage from 50kHz to 54MHz
  </li><li> Transmit and receiver image rejection > 110dB
</li><li> Full duplex operation, any split over entire 160m to 6m range
</li><li> Future expansion possible to eight independent receivers using the same antenna
</li><li> 500mW RF output on 160 – 6m amateur bands
</li><li> Built-in high performance preamp, with a noise floor typically -135dBm in 500Hz
</li><li> Software-selectable 31dB input attenuator in 1dB steps
</li><li> High performance receiver – same specifications as the HPSDR Mercury receiver (ie Blocking Dynamic Range typically about 125dB)
</li><li> FPGA code can be updated via the Ethernet connection
</li><li> Seven user-configurable open-collector outputs, independently 
selectable per band and Tx/Rx (for relay control, etc - with sequencing 
via PC code)
</li><li> Separate open-collector PTT connection for amplifier control, etc, with sequencer
</li><li> Microphone PTT jumper-selectable from tip or ring connection
</li><li> Bias for electret microphones via jumper
</li><li> Four user-configurable 12 bit analogue inputs (for ALC, SWR etc)
</li><li> Three user-configurable digital inputs (for linear amplifier over temperature, etc)
</li><li> Optional in-built switch mode power supply – less than xxxmA (receive) from a 13.8V supply
</li><li> I2C bus connector for control of external equipment
</li><li> Full QSK using the Kiss Konsole software, since digital signal
 processing is not used in the controlling PC for CW carrier generation
</li><li> Low-level transmitter output for transverter use (0dBm) as well as user-selectable output attenuator
</li><li> Stereo audio outputs at line and headphone levels
</li><li> In-built 1W stereo audio amplifier for directly driving speakers
</li><li> Direct, de-bounced connections for a Morse key (straight or iambic) and PTT
</li><li> 122.88MHz master clock, which can be phase-locked to an internal 10MHz TCXO or external frequency reference
</li><li> Jumper-selectable external frequency reference, with signal processing, to suit numerous GPS-locked 10MHz reference sources
</li><li> Direct ribbon cable interface to <a href="http://openhpsdr.org/wiki/index.php?title=Apollo" title="Apollo" class="mw-redirect">Apollo</a> 15W power amplifier, low pass filters and automatic ATU or <a href="http://openhpsdr.org/wiki/index.php?title=ALEXIARES" title="ALEXIARES">Alex</a> Antenna switch, HPFs and Tx LPFs
</li><li> Low noise, high efficiency, Switching Power Supply designed by Kjell Karson,LA2NI
</li><li> Ethernet interface supports fixed, APIP or DHCP IP address
</li><li> Hermes responds to ping and ARP requests, auto senses Ethernet cable connection and connection speed
</li></ul><p>Compare that to the commercial radios on any ham radio magazine...</p><p><br></p><p>I will keep my present setup and get one or maybe two...Hermes<img goomoji="gtalk.328" style="margin: 0pt 0.2ex; vertical-align: middle;" src="cid:gtalk.328@goomoji.gmail"></p>
<p><br></p><p>73, Luis NZ5U<br></p>